Holley Carburetor none User Manual

HOLLEY REPLACEMENT CARBURETOR  
GENERAL INSTALLATION INSTRUCTIONS  
To preserve warranty, these instructions must be read and followed thoroughly and completely both before  
and during installation. Holley Replacement Parts Division cannot and will not be responsible for any  
alleged engine or other damage, or other conditions resulting from misapplication of the carburetor  
described herein.  
WARNING! This carburetor is NOT desiqned for use with ANY automatic overdrive transmissions. If  
used on an automatic overdrive vehicle, SEVERE transmission damage WILL result.  
Prior to and after installing your replacement carburetor, manually operate the throttle lever and choke  
mechanism. Check for any throttle binding or other malfunction. Also, make a visual inspection of the  
carburetor, looking for bent levers, missing parts or any possible shipping damage. Because this replacement  
carburetor is designed to fit a variety of applications, It may provide more vacuum fitting tubes and/or hoses  
than the original carburetor. Some provided small parts might not be needed in various applications.  
REMOVAL:  
Before disconnecting the various hoses, linkages, and springs from original carburetor, it's advisable to tag each in  
some manner, so as to avoid confusion during installation of your replacement carburetor. Be sure to trace each  
line from original carburetor to its component, such as the distributor, then label that line. In the event that any  
components are strange or unknown, use a numbering system that corresponds each line to its component.  
1. Label and disconnect all vacuum hoses and electrical lines from the original carburetor. Disconnect the fuel  
line and retain the clamp.  
WARNING! Carefully protect the open end of the fuel line, so that no foreign particles can enter. Wrap the  
end of the fuel line with a clean lint-free cloth.  
2. Remove the carburetor hold down nuts. Loosen and remove the old carburetor. Place it over a suitable  
container and turn it upside down, in order to drain all the remaining gasoline from the fuel bowl. WIPE UP  
ANY SPILLED FUEL TO MINIMIZE A FIRE HAZARD.  
3. Clean the gasket surface thoroughly. Place a clean cloth over manifold opening to prevent any foreign  
materials from entering engine. Protect all exposed ends of lines and hoses from dirt contamination.  
CAUTION: Dirt entering the engine will impair vehicle performance and can cause expensive engine  
damage.  
INSTALLATION:  
1. Place the new carburetor next to original carburetor. Transfer any solenoids or dashpots from the original  
carburetor to new carburetor (if applicable).  
2. Place your new carburetor and gasket on the manifold and tighten down the hold down nuts.  
CAUTION: Overtightening the carburetor hold down nuts can result in a warped or cracked carburetor  
throttle body. The hold down nuts should be tiqhtened down progressively in a criss-cross  
pattern, first by hand, and then with the proper wrench. This procedure will prevent vacuum  
leaks, while avoiding damage to the carburetor.  
199R-9527  
Date: 2-2-04  

Brother IntelliFAX FAX 2920 User Manual
Bryant 538MNC User Manual
Canon PIXMA MG4120 Multifunction Printer 5290B002 User Manual
Carrier 42VMC User Manual
Fujitsu Air Conditioner AWU24CXQ User Manual
Goodman Mfg ARUF363616CA User Manual
Goodman Mfg CKLB30 1E User Manual
Haier Air Conditioner ESA405M User Manual
Heat Controller RADS 101H User Manual
Hitachi RAS 80YHA User Manual