Release the
5Install the
2
Transportation Lock
Ink Cartridges
Start
Here
1
Press the release button on the right side, then lift up the scanner, as shown.
1
Press the
Operate button. The
Operate light comes on and the
scanner carriage and print head move.
Operate button
2
Peel off the tape and remove the plastic piece from the front of the ink cartridge holders.
Remove the packing tape from the transportation lock.
2
Press the release button on the right side, then lift up the scanner.
3
Slide the transportation lock to the left.
3
4
Unwrap the ink cartridges and remove the yellow tape.
Warning: Keep ink cartridges out of the
reach of children. If ink gets on your skin,
wash the area thoroughly with soap and
water. If ink gets in your eyes, flush them
immediately with water.
Lift up the ink cartridge
clamps.
4
Carefully lower the scanner back down into place.
3
Attach the
Paper Support
5
6
Insert the ink cartridges with
the labels face-up.
1
Unpack Your
EPSON 1000 ICS
1
Make sure you have all the parts shown here. If any parts are missing,
contact EPSON as described in your Basics book.
Press down the ink cartridge
clamps until they snap shut.
Insert the paper support into its three slots.
7
8
Carefully lower the scanner back down into place.
Press the Copy button to begin charging the ink delivery system.
You’ll also need a USB cable (not included) to connect
the EPSON 1000 ICS to your computer.
2
Remove any tape and packing materials, as shown.
4
Plug In Your
EPSON 1000 ICS
Charging takes about two minutes.
The Operate light flashes and
the EPSON 1000 ICS makes various
sounds. Don’t turn it off while the
Operate light is flashing or you’ll
waste ink.
Do not remove
sticker from USB
port.
Caution: Don’t open the clamps to remove a cartridge except to replace it with a
new one. Once you remove a cartridge, you can’t reuse it, even if it contains ink.
You must install both cartridges and leave them installed for all types of printing.
To avoid damaging the EPSON 1000 ICS, never move the print head by hand.
Note: There may be additional packing materials or tape in locations
different from the ones shown in these illustrations. Do not remove
the sticker covering the USB port.
Plug the EPSON 1000 ICS into a grounded electrical outlet.
Do not connect the USB cable yet.
Turn over
|