Cateye SINGLE SHOT HL EL600RC User Manual

HOW TO USE  
CATEYE SINGLE SHOT  
ENG  
1
Lighting (lighting pattern selection)  
HL-EL600RC  
The lighting pattern is selected using a switch.  
Standard continu-  
Switch  
ous lighting time  
Pat. and Design Pat. Pending  
Copyright© 2007 CATEYE Co., Ltd.  
Switch  
ON OFF : Long press  
Hi  
: About 2 hours  
Hi Low : Single press  
Low : About 6 hours  
EL60RC-070620 066640130  
1
Flash  
: Quick double press Flash : About 24 hours  
INTRODUCTION  
Before using the light, please read this manual and the attached “NiMh  
Batteries” thoroughly, and keep them for future reference.  
Thank you very much for purchasing the CATEYE "SINGLE SHOT HL-EL600RC." This  
product is a high power rechargeable light unit that integrates a high power LED and a  
nickel metal-hydride rechargeable battery into a compact body.  
Double press  
ON  
Hi  
2 sec.  
x1  
FOR SAFE OPERATION  
• Do not place it within children's reach.  
Flash  
• In preparation for unexpected battery shutoff, we recommend you carry a dry-cell  
battery light unit with you.  
• If the light unit or parts become dirty with mud, etc., clean with a soft cloth which is  
moistened with mild soap. Never apply paint thinner, benzine or alcohol; damage  
will result.  
Double press  
OFF  
Low  
• Mount the light unit more than 10 cm away from the wireless meter. When it is  
mounted too close, the transmission may be affected adversely.  
• This product has waterproof features that allow you to use it in rain. Do not use it  
soaked in water.  
2
Remaining battery capacity  
Battery indicator  
When the battery indicator lights up red, the bat-  
tery is almost shutoff. Charge the battery as soon  
as possible.  
Before Initial Use  
Before shipment, it is charged enough to check the light. Be sure to charge it before use,  
according to the instructions "How to charge."  
3
How to charge  
Charge jack  
1�Open the charge jack cover at the  
back of the light unit to connect the  
battery charger plug.  
2�Plug the battery charger to an  
AC outlet.  
COMPONENTS  
Charging Indicator  
Battery charger  
Battery charger  
3�After charging, remove the plug  
and close the charge jack cover.  
Light unit  
H34 Bracket  
2
HOW TO MOUNT  
To AC power outlet  
* Be sure to use the special purpose battery  
charger.  
Bracket  
1�Wrap the bracket strap around the  
* Charging and lighting times are approximate  
values, and will vary by environmental and  
user conditions.  
Standard charg-  
ing time  
handlebar, and put it in the dial.  
2�Securely tighten the strap by turn-  
ing the dial.  
3�Cut off the excess bracket strap  
extending from the dial.  
4�I n s e r t t h e l i g h t u n i t t o  
the bracket until it clicks.  
To remove, pull out while pressing  
the release button.  
Charging indicator state  
Bracket rubber pad  
Blinking red light : Charging  
Approx. 5 hours  
Green light  
: Charging is completed  
2
HOW TO REPLACE BATTERY  
1�Remove 2 screws at the front of  
the lens using a 2.5 mm Allen  
wrench.  
2�Slowly pull out the lens unit from  
the body.  
3�Remove the battery connector con-  
nected to the board, and replace it  
with a new battery.  
4�Place the battery on the tray, and  
insert it to the body in place, and  
secure it with 2 screws.  
3
Bracket strap  
Dial  
Lens unit  
Body  
CAUTION!:  
*1  
• Make sure to tighten the dial by  
hand. If you tighten it too hard  
with a tool, the screw threads may  
be stripped.  
Screw  
2
Screw  
Battery  
• When the angle adjustment on the  
right and left sides is loose, tighten  
the screw (*1).  
Light unit  
• Round off the cut edge of the  
bracket strap to prevent injury.  
CAUTION!:  
Rubber packing  
• The lens unit is a precision part;  
therefore, never disassemble  
it. Otherwise, the optimum light  
distribution may be lost.  
4
Release button  
How to Adjust Beam Angle  
5�Slightly loosen the dial on the  
bracket.  
6�Adjust the light unit angle so that  
the light is not directed to oncom-  
ing cars.  
* When the dial is too firm to loosen, wash it  
slightly with water to loosen it.  
* Do not loosen the dial too much, or the bracket  
strap may come off. Loosen the dial just enough  
to allow the bracket to move slightly. Securely  
tighten the dial after adjusting the strap.  
* It can also be adjusted 10 degrees to the left  
and right.  
3
Battery connector  
To maintain its waterproof features,  
assemble the lens unit with a rubber  
packing-sheet correctly.  
• In order to avoid cable damage,  
when re-assembling the light,  
make sure the battery cable is  
routed inside the battery guide as  
shown below.  
Left side  
OK  
NO!  
6
Battry guide  
SPECIFICATIONS  
SPARE PARTS  
LIMITED WARRANTY  
Light source  
Battery  
High power white LED x 1  
NiMH 4.8v 780mAH  
2-year Warranty: Light unit / Battery charger  
(Deterioration of the battery is excluded.)  
#533-8827  
H34 Bracket  
Battery charger CHR-780mAH 4.8v NiMH  
Operating time Hi : Approx. 2 hours  
Low : Approx. 6 hours  
Flash : Approx. 24 hours  
Standard charging time  
Approx. 5 hours  
Temperature range Charging : 32˚F – 104˚F (0˚C – 40˚C)  
Operating : 5˚F – 113˚F (-15˚C – 45˚C)  
Recharge/discharge number of times  
CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from original  
purchase. If the product fails to work due to normal use, CatEye will repair or replace the defect at no charge. Service must  
be performed by CatEye or an authorized retailer. To return the product, pack it carefully and enclose the warranty certificate  
(proof or purchase) with instruction for repair. Please write or type your name and address clearly on the warranty certificate.  
Insurance, handling and transportation charges to CatEye shall be borne by person desiring service.  
#534-1859  
NiMH 4.8v 780mAH  
For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights.  
CO.,LTD.  
UL:#534-1860  
About 300 times (until the rated capacity drops to 50%)  
Dimensions/weight 3-17/64” x 2-23/64” x 1-1/2” (83 x 60 x 38 mm) / 4.09  
oz (116 g)  
UK:#534-1861  
2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan  
EC:#534-1862  
Attn : CATEYE Customer Service Section Phone : (06)6719-6863 Fax : (06)6719-6033 E-mail : [email protected] URL : http://www.cateye.co.jp  
Service & Research Address for USA  
AS:#534-1864  
CHR-780mAH 4.8v NiMH  
* The specifications and design are subject to change without notice.  
CATEYE Service and Research Center 1705 14th St. 115 Boulder, CO 80302  
Phone : 303.443.4595 Toll Free : 800.5CATEYE  
Fax : 303.473.0006  
E-mail : [email protected]  

Cannon Battery Charger Ch 910 User Manual
Carrier OMNIZONE 50XCA06 24 User Manual
Cisco Systems OL 23884 03 User Manual
Fedders AFPB36A1 User Manual
Fedders Split System Air Conditioner User Manual
Friedrich KM20 User Manual
Friedrich MS24Y3F User Manual
Haier AP42NACAAA User Manual
Havis Shields 2002 2008 Chevrolet Trailblazer GMC Envoy C TCB 32 User Manual
HP Hewlett Packard OFFICEJET 6100 User Manual