MODEL:
CK5888
AM/FM SHOWER RADIO with DIGITAL CLOCK
LOCATION OF CONTROLS AND INDICATIONS
FRONT
BACK
1. Speaker.
6
2. SET Button.
3. MODE Button.
4. Time/Date Display.
5. Fog Free Mirror.
6. Hanger.
5
7
8
7. Battery Compartment.
8. Power ON/OFF / Volume Control.
9. Tuning Control.
9
4
3
2
10
11
10. Band (AM/FM) Selector.
11. Stand.
1
POWER SOURCE
Battery Installation:
To install the batteries, (1.) Open the battery compartment located
on the rear of the unit by rotating the battery lock to the left or right.
(2.) Lift off the cover from the bottom edge. (3.) Insert three ‘AA’
batteries (not included) according to the polarity diagram in the
compartment. To put the battery compartment cover back on, slide
the top edge in first, pressing down on the bottom edge until it
locks in place. Rotate the lock back to the original position.
(3.)
(2.)
(1.)
BATTERY PRECAUTIONS
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. If the batteries are loaded
incorrectly the unit will not operate.
3. Do not mix different types of batteries together (e.g. alkaline and carbon-zinc) or old batteries with fresh ones.
4. If the device is not be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and repture.
CAUTION:
This unit is “Water Resistant” but it should not be placed in the direct path of the shower spray, and
it should never be fully immersed in water.
DESK OR TABLE TOP USE
This unit incorporates a stand which allows it to be used on a table or other flat surface. Just pull out
STAND
the built in stand on the back of the cabinet and let the unit rest on a desk, table or other flat surface.
TO SET THE DATE AND TIME
Note: Use the point of ball pen, a paper clip, or similar object to press the MODE and SET buttons.
1. Press the MODE button twice; the month will appear.
2. Press the SET button to set the month.
3. Press the MODE button; the day will appear.
4. Press the SET button to set the day.
MODE
SET
MODE
MODE
SET
SET
|