P100CCA Series Portable Tap
Installation Guide
To deploy the P100CCA Portable Tap into your network, simply:
Unpack the device and attach it to the optional rack mount bracket (RMS1U sold separately)
Install the P100CCA assembly into any available 1U slot of a network rack and secure it with rack mount screws
Using one straight-through Ethernet cable and one crossover cable, connect ports [A] and [B] of the P100CCA between the two live network devices where
monitoring is desired. Verify network traffic is flowing, confirming that network cabling is correct
Connect ports [C] and [D] to the monitoring tools for aggregated or combined network monitoring
Connect the power supply to the P100CCA and plug it in to an available power source
Note: One straight-through and one crossover cable must be used when connecting live network ports. This device may be deployed into 10M or 100Mbps
networks. Monitor ports are always 1Gbps, Auto Duplex and Auto MDI/MDIX
Link/Activity
LNK
LNK
LNK
LNK
LNK
LNK
LNK
LNK
Network
Passive
Monitor
Network
Monitor
1Gbps
10/100Mbps
Combined Outputs
LNK or L (Link/Activity): Solid when link is achieved and flashes
when Ethernet activity is detected on a particular interface.
Aggregation: An operating mode that combines data and allows
monitoring of complete traffic flows on one or more tap interfaces.
Passive: During power state changes, live network traffic remains
uninterrupted, keeping critical networks online, and data flowing.
Power Connector
This document is for informational purposes only. The information in this document, believed by Garland Technology to be accurate as of the date of publication, is subject to change without notice. Garland Technology assumes no responsibility for any errors
or omissions in this document and shall have no obligation to you as a result of having made this document available to you or based upon the information it contains. Copyright 2012 © Garland Technology LLC. All Rights Reserved.
|